It can be quite a job to find the best company to install your new water service. You’ll need to research various companies, talk to customers and get quotes to find one that offers you the best value. Don’t take the task of finding a company or a plumber too lightly. Your home’s water supply is important, and having an efficient system in place will save you time and money. Here are some tips for finding the right plumber.
If you’re having a new water service installation done, you’ll need a new water meter. This meter should be installed by Portland Plumbing, which is certified and trained in performing it. Some companies may use disposable meters, which are cheaper than those designed to withstand moisture. The meter is used to determine the amount of water flowing through the pipes in your home and determines when a customer’s next water bill is due. Customers who have meters with accurate information may experience inaccurate billing, which could lead to costly reconnection fees.
The location of the meter pit on your property line is important. This is typically where the customer’s water shut-off valve is located. Most companies have the proper connections installed, but sometimes they may send someone out to the property line to make sure it’s connected before they can begin working. A plumber will use the service line to snake the new water service line through the walls and pipes on your property, making it easier for him to install it.
Once he’s finished installing it, he’ll hook up the new water service line to the appropriate section of the pipes. He’ll then disconnect the old connection. The service line should now be visible, and it will be much easier for him to install it this way. When he’s finished, he’ll hook it back onto the pipe that runs to your house. Then he’ll install a valve on the tank to ensure it runs at the correct pressure. This new valve will prevent your commercial water bill from increasing for a couple of months until the plumbing issues are resolved.
The final step involves testing the new system. Before the plumber can test it, he’ll need to get all of the paperwork completed. He will obtain an opening permit from the local government, a copy of your building survey plans, a copy of your water meter inspection report, and a copy of your new water service agreement. He will then attach these documents to the meter. A licensed plumber must attach the meter, and he will only accept payment from you if the meter has been attached properly. If the opening permit isn’t available, he will ask for one from the local government.
When he gets all of these documents, he’ll attach them to the meter. This process is relatively painless and usually only takes about two or three hours. A good plumber will check all of the above documents before he starts his work. When he checks the water meter, he’ll see that it is attached correctly to the copper pipe, and he’ll know he’s found a leak in the system.
Once the plumber has successfully attached the meter, he’ll also test the water service runs to make sure it isn’t leaking. This is easier than it sounds, but you may need to use someone else’s water service if you’re going from one house to another. You may even have to purchase new water service equipment. You may need to purchase a new water line to replace the one you just destroyed in some cases. If the cracked water service runs aren’t on the copper pipe, then you may need to run new plumbing through it to accommodate the new water line you purchased.
After you’ve replaced the water service, the plumber will give you a certificate indicating that you’ve replaced your old system. Be sure to attach a copy of this certificate to your refrigerator or pipes and appliances so that you can show proof of your work. When you receive your money, be sure to use it to purchase new appliances, not to have to pay for the same things twice. Replacing a water main is a relatively simple process, but there are plenty of things to consider. Do your research and find a reliable contractor to do the job properly.